Development and Production Test Engineer – Electronic/Electrical

What are we looking for in our Development and Production Test Engineer – Electronic/Electrical ?

Development and Production Test Engineer – Electronic/Electrical – Stevenage – 6 – 12 months contract – SC needed before start - £36 per hour Umbrella

Our client is working on complex, challenging and innovative. It takes a range of professionals across the full engineering and commercial spectrum to carry it out. Whatever field our people specialise in, they all share the same mind-set: a drive to make things work better and to redefine the established standards

Please note that to apply for this opportunity you will need to be eligible for SC

Role Responsibilities:

Provide Test Engineering support during Design / Development phases from initial concept through to Production Readiness Review and release to Operations.

• Support Test Facility introduction and ensure that configuration control of equipment and facilities is in place prior to use, including generating supporting test specifications and operator instructions.
• Support to testing of electrical/electronic weapon systems and sub-assemblies, with diagnosis of production test failures down to circuit card and potentially component level.
• Identification of remedial and corrective actions, in a timely manner allowing Manufacturing to continue production in line with programme.
• Evaluation of technical problems in order to develop proposals for test equipment investigations and corrective actions, including process improvements.
• Test Engineering representative at Defect Review Board meetings to ensure efficient progress of equipment and quality notifications towards corrective action. Role requirements (skills, training and qualifications)
• HNC/HND (Electronics) Level of Qualifications or equivalent, plus good level of experience in digital & analogue electronics manufacture and test.
• A good understanding of measurement and test principles, and associated test equipment.
• An understanding of the typical CADMID product lifecycle for test equipment is desirable.
• An understanding of RF and microwave technology at subsystem level would be an advantage.
• An understanding of Environmental testing (including ESS) would also be an advantage.
• Good verbal and written communication skills, including generation of test specifications, operator instructions and technical reports based on higher-level requirements.
• Proven analytical and problem solving skills, with strong attention to detail.
• The ability to plan and organise own work in order to ensure multiple tasks can be prioritised and delivered against Project objectives.
• Manual handling training.

Essential qualifications:

• HNC/HND (Electronics) or equivalent